What are the laser detector error glitch during installation? How to solve it?

As a mature perimeter security alarm series, the performance of the laser detector ensures that it has strong environmental adaptability and superior outer casing protection, so that the inside of the detector is well protected, but the laser is detected. There are always some common glitch in the process of using and installing the device . As long as we understand it a little, we can solve it ourselves, which is very practical.

When the laser detector is in use, the most important thing is to rely on the laser at the front end to prevent the area, but sometimes there will be "zone false alarm" and "zone no alarm". This time you need Check to see if there are any stains on the lens at the transmitting end and the receiving end, and to see if there is any obstruction on the path of the laser beam. These are the factors that affect the false alarm. Because the laser has a large density of radiation and the beam is concentrated, it is basically not There will be cases of false positives due to environmental factors. For the case where the "zone does not alarm", there are three possibilities, 1. the device crashes, 2, the zone is bypassed, 3. the system is not armed. You can check each of these three different situations one by one, restart the device after power off or cancel the bypass setting and perform the arming test.

In addition to the front-end laser beaming is prone to problems, the alarm host and keyboard are also small problems during installation, such as the keyboard is always ringing, in this case, if the front end is all normal, it may be that the port wiring behind the keyboard is loose, the connection has problems, will The wiring can be tightened to solve it. The alarm host not only needs to be connected to each device during installation, but also needs to be powered on. Otherwise, it will not give you any reaction.

Most of the glitch during installation is because the installation is not careful enough, as long as we can follow the installation instructions step by step, to ensure that each step is correct, basically no such problem.

EDM Graphite

EDM graphite, also known as graphite block for EDM, is a new type of material, which is now more and more widely used in the precision mold processing industry. At present, in mold processing plants in developed European countries, more than 90% of mold processing electrode materials are graphite. Copper, the once dominant electrode material, has almost lost its advantages compared with graphite electrodes.

Our isostatic graphite and Molded Graphite were tested at the National Electrical Carbon Products Quality Supervision and Inspection Center. The main physical and chemical performance index as follows: the compressive strength--125 mpa, shore hardness -- 65 degrees, resistivity --12 mu Ω m. At the same time, the 10μm,8μm,6μm,4μm products have already began Large-scale production,.and unanimously acknowledged by customers. The 2μm,1μm graphite products are under trial. Our company high quality of isostatic pressing special graphite yield above 90%, far ahead of industry the yield of 70%, the first in the country.

Edm Graphite,Graphite Block For Edm,Edm Graphite Electrodes,Isostatic Graphite Column

Henan Carbons New Material Technology Co., Ltd. , https://www.kygraphitematerial.com